How to prevent erroneous measurement due to the saturation of the spectrum analyzer
How to prevent erroneous measurement due to the higher power input signal out of measurement band. Application When the input signal power is higher than the proper level for 1st […]
A measurement example of real time mode trigger function with the signal analyzer
In real time mode of signal analyzer MSA500 series, p owerful trigger functions can be used.
By using these trigger functions, the signal can be measured immediately before and after the change has occurred in the waveform.
Visualization of the modulation signal by a signal analyzer
The various modulation signals can be visually observed with a handheld real time signal analyzer. Application Connection block diagram Solution Set the measurement mode to “real time mode” after connecting […]
Dynamic range expansion method for spectrum analyzer with tracking generator
The dynamic range expansion method of the spectrum analyzer with tracking generator (TG) by utilizing a low-noise amplifier. Application The dynamic range of spectrum analyzer with tracking generator is limited […]
Calculation of antenna factor and gain
The calculation equation useful for mutual conversion of an antenna factor and gain is presented. Application Solution System configuration Products introduction
How to install antenna calibration data to spectrum analyzer(MSA400 series)
The electric field strength can be measured connecting your antenna to our spectrum analyzer. Application Usually, the electric field strength (dBμ/m) is measured in order to confirm how the radio […]
How to increase the work efficiency at night
When using a spectrum analyzer in the dark place, the problem that the characters of soft key can’t be read will be solved. Application In general surveys of radio wave, […]
Detect disturbance waves with a signal analyzer
The disturbance waves can be detected and analyzed using the power trigger function of signal analyzer MS500 series. Application Connection schematic drawing Solution Match the frequency detected by the signal […]